Connect a Dust collector 5 in inlet to a 1-1/4 in shop-vac hose
How to join a Dust collector 5 in inlet to a 1-1/4 in shop-vac hose, and what stops it leaking dust.
Not compatible without stepping down. A 1-1/4 in shop-vac hose is far larger than the Dust collector 5 in inlet, so it needs a 5 in to 1-1/4 in step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Dust collector 5 in inlet (5 in ID) |
|---|---|
| End B | 1-1/4 in shop-vac hose (approx 1-1/2 cuff in OD, 1-1/4 in ID) |
| Fit type | hose cuff into female socket |
| Reducer needed | 5 in to 1-1/4 in step reducer |
Shop notes
The hose tip is about 32 mm and the port socket about 127 mm, a gap of 95 mm, so the port socket simply swallows the hose tip with no contact. A 5 in to 1-1/4 in step reducer is needed, and even reduced the airflow is mismatched between the Dust collector 5 in inlet and the 1-1/4 in shop-vac hose.
Wrapping tape to close a 95 mm gap never seals cleanly and chokes the airflow further. Step the sizes properly, or pair each end with a fitting closer to its own size.
The reducer to buy
Shop 5 in to 1-1/4 in step reducer on AmazonaffiliateFind 5 in to 1-1/4 in step reducer on eBayaffiliateRelated connections
- Dust collector 5 in inlet5 in inlet (approx 127 mm)
- 1-1/4 in shop-vac hose1-1/4 in (approx 32 mm)
- DeWalt DWS779 / DWS780 miter saw port to 1-1/4 in shop-vac hoseneeds a reducer
- DeWalt random-orbit sander stepped port to 1-1/4 in shop-vac hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to 1-1/4 in shop-vac hoseneeds a reducer
- 1-1/4 in shop-vac hose to 2-1/2 in shop-vac hoseneeds a reducer