Connect a 1-1/4 in shop-vac hose to a 6 in dust-collector hose
How to join a 1-1/4 in shop-vac hose to a 6 in dust-collector hose, and what stops it leaking dust.
Not compatible without stepping down. A 6 in dust-collector hose is far larger than the 1-1/4 in shop-vac hose, so it needs a 1-1/4 in to 6 in step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | 1-1/4 in shop-vac hose (approx 1-1/2 cuff in OD, 1-1/4 in ID) |
|---|---|
| End B | 6 in dust-collector hose (6 in ID) |
| Fit type | cuff to cuff via a step reducer |
| Reducer needed | 1-1/4 in to 6 in step reducer |
Shop notes
The smaller hose is about 32 mm and the hose about 152 mm, a gap of 120 mm, so the hose simply swallows the smaller hose with no contact. A 1-1/4 in to 6 in step reducer is needed, and even reduced the airflow is mismatched between the 1-1/4 in shop-vac hose and the 6 in dust-collector hose.
Wrapping tape to close a 120 mm gap never seals cleanly and chokes the airflow further. Step the sizes properly, or pair each end with a fitting closer to its own size.
The reducer to buy
Shop 1-1/4 in to 6 in step reducer on AmazonaffiliateFind 1-1/4 in to 6 in step reducer on eBayaffiliateRelated connections
- 1-1/4 in shop-vac hose1-1/4 in (approx 32 mm)
- 6 in dust-collector hose6 in ID (approx 152 mm)
- DeWalt DWS779 / DWS780 miter saw port to 1-1/4 in shop-vac hoseneeds a reducer
- DeWalt random-orbit sander stepped port to 1-1/4 in shop-vac hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to 1-1/4 in shop-vac hoseneeds a reducer
- 1-1/4 in shop-vac hose to 2-1/2 in shop-vac hoseneeds a reducer