Connect a DeWalt DWE7491RS blade-guard port to a 1-1/4 in shop-vac hose
How to join a DeWalt DWE7491RS blade-guard port to a 1-1/4 in shop-vac hose, and what stops it leaking dust.
Not a direct fit. Joining the DeWalt DWE7491RS blade-guard port to a 1-1/4 in shop-vac hose needs a 1-1/2 in to 1-1/4 in step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | DeWalt DWE7491RS blade-guard port (1-1/2 in OD, 38 mm OD) |
|---|---|
| End B | 1-1/4 in shop-vac hose (approx 1-1/2 cuff in OD, 1-1/4 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | 1-1/2 in to 1-1/4 in step reducer |
Shop notes
Measured across the joint between the DeWalt DWE7491RS blade-guard port and the 1-1/4 in shop-vac hose, the port (38 mm) is 6 mm larger than the hose (32 mm), so it will not seat. A 1-1/2 in to 1-1/4 in step reducer closes that 6 mm step so the two hold together instead of leaking at the gap.
A 6 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
The reducer to buy
Search Amazon for 1-1/2 in to 1-1/4 in step reduceraffiliate searchRelated connections
- DeWalt DWE7491RS blade-guard port1-1/2 in OD guard port
- 1-1/4 in shop-vac hose1-1/4 in (approx 32 mm)
- DeWalt DWS779 / DWS780 miter saw port to 1-1/4 in shop-vac hoseneeds a reducer
- DeWalt random-orbit sander stepped port to 1-1/4 in shop-vac hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to 1-1/4 in shop-vac hoseneeds a reducer
- 1-1/4 in shop-vac hose to 2-1/2 in shop-vac hoseneeds a reducer