Connect a Metabo HPT C10FCG miter saw port to a 2-1/2 in shop-vac hose
How to join a Metabo HPT C10FCG miter saw port to a 2-1/2 in shop-vac hose, and what stops it leaking dust.
Not a direct fit. Joining the Metabo HPT C10FCG miter saw port to a 2-1/2 in shop-vac hose needs a 1-1/4 in to 2-1/2 in step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Metabo HPT C10FCG miter saw port (1-3/8 in OD, 35 mm OD) |
|---|---|
| End B | 2-1/2 in shop-vac hose (2-1/4 in OD, 2-1/4 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | 1-1/4 in to 2-1/2 in step reducer |
Shop notes
Measured across the joint between the Metabo HPT C10FCG miter saw port and the 2-1/2 in shop-vac hose, the hose (57 mm) is 22 mm larger than the port (35 mm), so the port rattles inside without gripping. A 1-1/4 in to 2-1/2 in step reducer closes that 22 mm step so the two hold together instead of leaking at the gap.
A 22 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
The reducer to buy
Shop 1-1/4 in to 2-1/2 in step reducer on AmazonaffiliateFind 1-1/4 in to 2-1/2 in step reducer on eBayaffiliateRelated connections
- Metabo HPT C10FCG miter saw port1-1/4 in / 35 mm dust port class
- 2-1/2 in shop-vac hose2-1/2 in nominal, cuff approx 2-1/4 in OD
- DeWalt DWS779 / DWS780 miter saw port to 2-1/2 in shop-vac hoseneeds a reducer
- Router table fence port to 2-1/2 in shop-vac hosedirect fit
- SawStop table-saw rear guard port to 2-1/2 in shop-vac hosedirect fit
- Festool 36 mm (D36) tool port to 2-1/2 in shop-vac hoseneeds a reducer