Connect a Festool 36 mm (D36) tool port to a Festool D32/22 antistatic hose
How to join a Festool 36 mm (D36) tool port to a Festool D32/22 antistatic hose, and what stops it leaking dust.
Not a direct fit. Joining the Festool 36 mm (D36) tool port to a Festool D32/22 antistatic hose needs a 36 mm to 22 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Festool 36 mm (D36) tool port (1-3/4 in OD, 44 mm OD) |
|---|---|
| End B | Festool D32/22 antistatic hose (7/8 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | 36 mm to 22 mm step reducer |
Shop notes
Measured across the joint between the Festool 36 mm (D36) tool port and the Festool D32/22 antistatic hose, the port (44 mm) is 22 mm larger than the hose (22 mm), so it will not seat. A 36 mm to 22 mm step reducer closes that 22 mm step so the two hold together instead of leaking at the gap.
A 22 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
The reducer to buy
Search Amazon for 36 mm to 22 mm step reduceraffiliate searchRelated connections
- Festool 36 mm (D36) tool port36 mm nominal, hose tip 38 mm ID / 44 mm OD
- Festool D32/22 antistatic hose22 mm tool end, tapered to 32 mm
- Festool 36 mm (D36) tool port to Festool 27 mm (D27) tool portneeds a reducer
- Festool 36 mm (D36) tool port to 2-1/2 in shop-vac hoseneeds a reducer
- DeWalt DWS779 / DWS780 miter saw port to Festool D32/22 antistatic hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Festool D32/22 antistatic hoseneeds a reducer