Connect a Festool 36 mm (D36) tool port to a Festool D27 antistatic hose
How to join a Festool 36 mm (D36) tool port to a Festool D27 antistatic hose, and what stops it leaking dust.
Not a direct fit. Joining the Festool 36 mm (D36) tool port to a Festool D27 antistatic hose needs a 36 mm to 27 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Festool 36 mm (D36) tool port (1-3/4 in OD, 44 mm OD) |
|---|---|
| End B | Festool D27 antistatic hose (35 mm tip in OD, 7/8 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | 36 mm to 27 mm step reducer |
Shop notes
Measured across the joint between the Festool 36 mm (D36) tool port and the Festool D27 antistatic hose, the port (44 mm) is 21 mm larger than the hose (23 mm), so it will not seat. A 36 mm to 27 mm step reducer closes that 21 mm step so the two hold together instead of leaking at the gap.
A 21 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
The reducer to buy
Search Amazon for 36 mm to 27 mm step reduceraffiliate searchRelated connections
- Festool 36 mm (D36) tool port36 mm nominal, hose tip 38 mm ID / 44 mm OD
- Festool D27 antistatic hose27 mm nominal, tip 23 mm ID / 35 mm OD
- Festool 36 mm (D36) tool port to Festool 27 mm (D27) tool portneeds a reducer
- Festool 36 mm (D36) tool port to 2-1/2 in shop-vac hoseneeds a reducer
- DeWalt DWS779 / DWS780 miter saw port to Festool D27 antistatic hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Festool D27 antistatic hoseneeds a reducer