CONNECTION
Connect a Kreg 720 Pro pocket-hole jig port to a Makita 28 mm anti-static hose
How to join a Kreg 720 Pro pocket-hole jig port to a Makita 28 mm anti-static hose, and what stops it leaking dust.
Direct fit
These connect directly. A Makita 28 mm anti-static hose seats on the Kreg 720 Pro pocket-hole jig port with no reducer.
END B28 mmMakita 28 mm anti-static hose (1-1/8 in ID)
END A26.9875 mmKreg 720 Pro pocket-hole jig port (1-1/16 in ID)
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Kreg 720 Pro pocket-hole jig port (1-1/16 in ID) |
|---|---|
| End B | Makita 28 mm anti-static hose (1-1/8 in ID) |
| Fit type | hose cuff into female socket |
| Reducer needed | none, direct friction fit |
Shop notes
The hose tip measures about 28 mm and the port socket about 27 mm, only 1 mm apart, so the hose tip seats inside the port socket as a friction fit. No reducer is needed for this pairing, so the Kreg 720 Pro pocket-hole jig port and the Makita 28 mm anti-static hose connect directly.
It is a push fit, not a lock. Seat it fully and check it has not crept loose after a few minutes of vibration before you trust it on fine dust.
Related connections
- Kreg 720 Pro pocket-hole jig porttakes a 27 mm hose tip
- Makita 28 mm anti-static hose28 mm (1-1/8 in)
- DeWalt DWS779 / DWS780 miter saw port to Makita 28 mm anti-static hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Makita 28 mm anti-static hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Makita 28 mm anti-static hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Makita 28 mm anti-static hoseneeds a reducer