Connect a Festool 27 mm (D27) tool port to a Festool D36 antistatic hose
How to join a Festool 27 mm (D27) tool port to a Festool D36 antistatic hose, and what stops it leaking dust.
Not a direct fit. Joining the Festool 27 mm (D27) tool port to a Festool D36 antistatic hose needs a 27 mm to 36 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Festool 27 mm (D27) tool port (1-1/16 in OD, 27 mm OD) |
|---|---|
| End B | Festool D36 antistatic hose (44 mm tip in OD, 1-1/2 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | 27 mm to 36 mm step reducer |
Shop notes
Measured across the joint between the Festool 27 mm (D27) tool port and the Festool D36 antistatic hose, the hose (38 mm) is 11 mm larger than the port (27 mm), so the port rattles inside without gripping. A 27 mm to 36 mm step reducer closes that 11 mm step so the two hold together instead of leaking at the gap.
A 11 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
The reducer to buy
Search Amazon for 27 mm to 36 mm step reduceraffiliate searchRelated connections
- Festool 27 mm (D27) tool port27 mm nominal, hose tip 23 mm ID / 35 mm OD
- Festool D36 antistatic hose36 mm nominal, tip 38 mm ID / 44 mm OD
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Festool 27 mm (D27) tool portdirect fit
- Festool 36 mm (D36) tool port to Festool 27 mm (D27) tool portneeds a reducer
- DeWalt DWS779 / DWS780 miter saw port to Festool D36 antistatic hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Festool D36 antistatic hosedirect fit