Connect a Festool 27 mm (D27) tool port to a 4 in dust-collector hose
How to join a Festool 27 mm (D27) tool port to a 4 in dust-collector hose, and what stops it leaking dust.
Not compatible without stepping down. A 4 in dust-collector hose is far larger than the Festool 27 mm (D27) tool port, so it needs a 27 mm to 4 in step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Festool 27 mm (D27) tool port (1-1/16 in OD, 27 mm OD) |
|---|---|
| End B | 4 in dust-collector hose (4-1/4 port in OD, 4 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | 27 mm to 4 in step reducer |
Shop notes
The port is about 27 mm and the hose about 102 mm, a gap of 75 mm, so the hose simply swallows the port with no contact. A 27 mm to 4 in step reducer is needed, and even reduced the airflow is mismatched between the Festool 27 mm (D27) tool port and the 4 in dust-collector hose.
Wrapping tape to close a 75 mm gap never seals cleanly and chokes the airflow further. Step the sizes properly, or pair each end with a fitting closer to its own size.
The reducer to buy
Search Amazon for 27 mm to 4 in step reduceraffiliate searchRelated connections
- Festool 27 mm (D27) tool port27 mm nominal, hose tip 23 mm ID / 35 mm OD
- 4 in dust-collector hose4 in ID
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Festool 27 mm (D27) tool portdirect fit
- SawStop table-saw rear guard port to 4 in dust-collector hosenot compatible
- Festool 36 mm (D36) tool port to Festool 27 mm (D27) tool portneeds a reducer
- 4 in dust-collector hose to 2-1/2 in shop-vac hoseneeds a reducer