Connect a Router table fence port to a Fein Turbo 35 mm hose
How to join a Router table fence port to a Fein Turbo 35 mm hose, and what stops it leaking dust.
Not compatible without stepping down. A Fein Turbo 35 mm hose is far larger than the Router table fence port, so it needs a 2-1/2 in to 35 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Router table fence port (2-11/16 in OD, 2-1/2 in ID) |
|---|---|
| End B | Fein Turbo 35 mm hose (1-3/8 in ID) |
| Fit type | hose cuff into female socket |
| Reducer needed | 2-1/2 in to 35 mm step reducer |
Shop notes
The hose tip is about 35 mm and the port socket about 64 mm, a gap of 28 mm, so the port socket simply swallows the hose tip with no contact. A 2-1/2 in to 35 mm step reducer is needed, and even reduced the airflow is mismatched between the Router table fence port and the Fein Turbo 35 mm hose.
Wrapping tape to close a 28 mm gap never seals cleanly and chokes the airflow further. Step the sizes properly, or pair each end with a fitting closer to its own size.
The reducer to buy
Search Amazon for 2-1/2 in to 35 mm step reduceraffiliate searchRelated connections
- Router table fence port2-1/2 in ID, 2-11/16 in OD
- Fein Turbo 35 mm hose35 mm diameter
- Router table fence port to 2-1/2 in shop-vac hosedirect fit
- DeWalt DWS779 / DWS780 miter saw port to Fein Turbo 35 mm hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Fein Turbo 35 mm hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Fein Turbo 35 mm hosedirect fit