Connect a Makita 24 mm tool cuff to a Makita 28 mm anti-static hose
How to join a Makita 24 mm tool cuff to a Makita 28 mm anti-static hose, and what stops it leaking dust.
Not a direct fit. Joining the Makita 24 mm tool cuff to a Makita 28 mm anti-static hose needs a 24 mm to 28 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Makita 24 mm tool cuff (15/16 in OD, 24 mm OD) |
|---|---|
| End B | Makita 28 mm anti-static hose (1-1/8 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | 24 mm to 28 mm step reducer |
Shop notes
Measured across the joint between the Makita 24 mm tool cuff and the Makita 28 mm anti-static hose, the hose (28 mm) is 4 mm larger than the port (24 mm), so the port rattles inside without gripping. A 24 mm to 28 mm step reducer closes that 4 mm step so the two hold together instead of leaking at the gap.
A 4 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
The reducer to buy
Shop 24 mm to 28 mm step reducer on AmazonaffiliateFind 24 mm to 28 mm step reducer on eBayaffiliateRelated connections
- Makita 24 mm tool cuff24 mm / 22 mm cuff for 1 in hose
- Makita 28 mm anti-static hose28 mm (1-1/8 in)
- DeWalt DWS779 / DWS780 miter saw port to Makita 28 mm anti-static hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Makita 28 mm anti-static hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Makita 28 mm anti-static hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Makita 28 mm anti-static hoseneeds a reducer