Connect a Makita SP6000 track saw port to a Festool D27 antistatic hose
How to join a Makita SP6000 track saw port to a Festool D27 antistatic hose, and what stops it leaking dust.
Not a direct fit. Joining the Makita SP6000 track saw port to a Festool D27 antistatic hose needs a hose 27 mm ID / 36 mm OD tool end to 27 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Makita SP6000 track saw port (1-7/16 in OD, 36 mm OD) |
|---|---|
| End B | Festool D27 antistatic hose (35 mm tip in OD, 7/8 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | hose 27 mm ID / 36 mm OD tool end to 27 mm step reducer |
Shop notes
Measured across the joint between the Makita SP6000 track saw port and the Festool D27 antistatic hose, the port (36 mm) is 13 mm larger than the hose (23 mm), so it will not seat. A hose 27 mm ID / 36 mm OD tool end to 27 mm step reducer closes that 13 mm step so the two hold together instead of leaking at the gap.
A 13 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
The reducer to buy
Shop hose 27 mm ID / 36 mm OD tool end to 27 mm step reducer on AmazonaffiliateFind hose 27 mm ID / 36 mm OD tool end to 27 mm step reducer on eBayaffiliateRelated connections
- Makita SP6000 track saw porthose 27 mm ID / 36 mm OD tool end
- Festool D27 antistatic hose27 mm nominal, tip 23 mm ID / 35 mm OD
- DeWalt DWS779 / DWS780 miter saw port to Festool D27 antistatic hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Festool D27 antistatic hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Festool D27 antistatic hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Festool D27 antistatic hoseneeds a reducer