Connect a Kreg 720 Pro pocket-hole jig port to a Festool D50 antistatic hose
How to join a Kreg 720 Pro pocket-hole jig port to a Festool D50 antistatic hose, and what stops it leaking dust.
Not a direct fit. Joining the Kreg 720 Pro pocket-hole jig port to a Festool D50 antistatic hose needs a takes a 27 mm hose tip to 50 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Kreg 720 Pro pocket-hole jig port (1-1/16 in ID) |
|---|---|
| End B | Festool D50 antistatic hose (1-15/16 in ID) |
| Fit type | hose cuff into female socket |
| Reducer needed | takes a 27 mm hose tip to 50 mm step reducer |
Shop notes
Measured across the joint between the Kreg 720 Pro pocket-hole jig port and the Festool D50 antistatic hose, the hose tip (50 mm) is 23 mm larger than the port socket (27 mm), so it will not seat. A takes a 27 mm hose tip to 50 mm step reducer closes that 23 mm step so the two hold together instead of leaking at the gap.
A 23 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
Related connections
- Kreg 720 Pro pocket-hole jig porttakes a 27 mm hose tip
- Festool D50 antistatic hose50 mm nominal (1-15/16 in)
- DeWalt DWS779 / DWS780 miter saw port to Festool D50 antistatic hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Festool D50 antistatic hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Festool D50 antistatic hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Festool D50 antistatic hoseneeds a reducer