Connect a Kreg 720 Pro pocket-hole jig port to a Fein Turbo 35 mm hose
How to join a Kreg 720 Pro pocket-hole jig port to a Fein Turbo 35 mm hose, and what stops it leaking dust.
Not a direct fit. Joining the Kreg 720 Pro pocket-hole jig port to a Fein Turbo 35 mm hose needs a takes a 27 mm hose tip to 35 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Kreg 720 Pro pocket-hole jig port (1-1/16 in ID) |
|---|---|
| End B | Fein Turbo 35 mm hose (1-3/8 in ID) |
| Fit type | hose cuff into female socket |
| Reducer needed | takes a 27 mm hose tip to 35 mm step reducer |
Shop notes
Measured across the joint between the Kreg 720 Pro pocket-hole jig port and the Fein Turbo 35 mm hose, the hose tip (35 mm) is 8 mm larger than the port socket (27 mm), so it will not seat. A takes a 27 mm hose tip to 35 mm step reducer closes that 8 mm step so the two hold together instead of leaking at the gap.
A 8 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
Related connections
- Kreg 720 Pro pocket-hole jig porttakes a 27 mm hose tip
- Fein Turbo 35 mm hose35 mm diameter
- DeWalt DWS779 / DWS780 miter saw port to Fein Turbo 35 mm hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Fein Turbo 35 mm hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Fein Turbo 35 mm hosedirect fit
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Fein Turbo 35 mm hosedirect fit