Connect a Oneida Dust Deputy 2-1/2 in inlet to a Makita 28 mm anti-static hose
How to join a Oneida Dust Deputy 2-1/2 in inlet to a Makita 28 mm anti-static hose, and what stops it leaking dust.
Not compatible without stepping down. A Makita 28 mm anti-static hose is far larger than the Oneida Dust Deputy 2-1/2 in inlet, so it needs a 2-1/2 in to 28 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Oneida Dust Deputy 2-1/2 in inlet (2-1/4 in ID) |
|---|---|
| End B | Makita 28 mm anti-static hose (1-1/8 in ID) |
| Fit type | hose cuff into female socket |
| Reducer needed | 2-1/2 in to 28 mm step reducer |
Shop notes
The hose tip is about 28 mm and the port socket about 57 mm, a gap of 29 mm, so the port socket simply swallows the hose tip with no contact. A 2-1/2 in to 28 mm step reducer is needed, and even reduced the airflow is mismatched between the Oneida Dust Deputy 2-1/2 in inlet and the Makita 28 mm anti-static hose.
Wrapping tape to close a 29 mm gap never seals cleanly and chokes the airflow further. Step the sizes properly, or pair each end with a fitting closer to its own size.
The reducer to buy
Shop 2-1/2 in to 28 mm step reducer on AmazonaffiliateFind 2-1/2 in to 28 mm step reducer on eBayaffiliateRelated connections
- Oneida Dust Deputy 2-1/2 in inlet2-1/2 in inlet / outlet
- Makita 28 mm anti-static hose28 mm (1-1/8 in)
- DeWalt DWS779 / DWS780 miter saw port to Makita 28 mm anti-static hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Makita 28 mm anti-static hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Makita 28 mm anti-static hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Makita 28 mm anti-static hoseneeds a reducer