CONNECTION
Connect a Skilsaw SPT99T table saw port to a 2-1/2 in Ridgid / Craftsman locking hose
How to join a Skilsaw SPT99T table saw port to a 2-1/2 in Ridgid / Craftsman locking hose, and what stops it leaking dust.
Direct fit
These connect directly. A 2-1/2 in Ridgid / Craftsman locking hose seats on the Skilsaw SPT99T table saw port with no reducer.
END B63.5 mm2-1/2 in Ridgid / Craftsman locking hose (2-1/4 in OD, 2-1/4 in ID)
END A57.1 mmSkilsaw SPT99T table saw port (2-1/4 in ID)
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Skilsaw SPT99T table saw port (2-1/4 in ID) |
|---|---|
| End B | 2-1/2 in Ridgid / Craftsman locking hose (2-1/4 in OD, 2-1/4 in ID) |
| Fit type | hose cuff into female socket |
| Reducer needed | none, direct friction fit |
Shop notes
The hose tip measures about 57 mm and the port socket about 57 mm, the same, so the hose tip seats inside the port socket as a friction fit. No reducer is needed for this pairing, so the Skilsaw SPT99T table saw port and the 2-1/2 in Ridgid / Craftsman locking hose connect directly.
It is a push fit, not a lock. Seat it fully and check it has not crept loose after a few minutes of vibration before you trust it on fine dust.
Related connections
- Skilsaw SPT99T table saw port2-1/4 in ID for a 2-1/2 in hose
- 2-1/2 in Ridgid / Craftsman locking hose2-1/2 in, cuff approx 2-1/4 in OD
- DeWalt DWS779 / DWS780 miter saw port to 2-1/2 in Ridgid / Craftsman locking hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to 2-1/2 in Ridgid / Craftsman locking hoseneeds a reducer
- DeWalt random-orbit sander stepped port to 2-1/2 in Ridgid / Craftsman locking hoseneeds a reducer
- DeWalt DW735 planer port to 2-1/2 in Ridgid / Craftsman locking hoseneeds a reducer