Connect a Skilsaw SPT99T table saw port to a Festool D27 antistatic hose
How to join a Skilsaw SPT99T table saw port to a Festool D27 antistatic hose, and what stops it leaking dust.
Not a direct fit. Joining the Skilsaw SPT99T table saw port to a Festool D27 antistatic hose needs a 2-1/4 in to 27 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Skilsaw SPT99T table saw port (2-1/4 in ID) |
|---|---|
| End B | Festool D27 antistatic hose (35 mm tip in OD, 7/8 in ID) |
| Fit type | hose cuff into female socket |
| Reducer needed | 2-1/4 in to 27 mm step reducer |
Shop notes
Measured across the joint between the Skilsaw SPT99T table saw port and the Festool D27 antistatic hose, the port socket (57 mm) is 22 mm larger than the hose tip (35 mm), so the hose tip rattles inside without gripping. A 2-1/4 in to 27 mm step reducer closes that 22 mm step so the two hold together instead of leaking at the gap.
A 22 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
The reducer to buy
Search Amazon for 2-1/4 in to 27 mm step reduceraffiliate searchRelated connections
- Skilsaw SPT99T table saw port2-1/4 in ID for a 2-1/2 in hose
- Festool D27 antistatic hose27 mm nominal, tip 23 mm ID / 35 mm OD
- DeWalt DWS779 / DWS780 miter saw port to Festool D27 antistatic hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Festool D27 antistatic hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Festool D27 antistatic hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Festool D27 antistatic hoseneeds a reducer