Connect a Skilsaw SPT99T table saw port to a Fein Turbo 35 mm hose
How to join a Skilsaw SPT99T table saw port to a Fein Turbo 35 mm hose, and what stops it leaking dust.
Not a direct fit. Joining the Skilsaw SPT99T table saw port to a Fein Turbo 35 mm hose needs a 2-1/4 in to 35 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Skilsaw SPT99T table saw port (2-1/4 in ID) |
|---|---|
| End B | Fein Turbo 35 mm hose (1-3/8 in ID) |
| Fit type | hose cuff into female socket |
| Reducer needed | 2-1/4 in to 35 mm step reducer |
Shop notes
Measured across the joint between the Skilsaw SPT99T table saw port and the Fein Turbo 35 mm hose, the port socket (57 mm) is 22 mm larger than the hose tip (35 mm), so the hose tip rattles inside without gripping. A 2-1/4 in to 35 mm step reducer closes that 22 mm step so the two hold together instead of leaking at the gap.
A 22 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
The reducer to buy
Search Amazon for 2-1/4 in to 35 mm step reduceraffiliate searchRelated connections
- Skilsaw SPT99T table saw port2-1/4 in ID for a 2-1/2 in hose
- Fein Turbo 35 mm hose35 mm diameter
- DeWalt DWS779 / DWS780 miter saw port to Fein Turbo 35 mm hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Fein Turbo 35 mm hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Fein Turbo 35 mm hosedirect fit
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Fein Turbo 35 mm hosedirect fit