CONNECTION
Connect a Ryobi sander port to a Festool D27 antistatic hose
How to join a Ryobi sander port to a Festool D27 antistatic hose, and what stops it leaking dust.
Direct fit
These connect directly. A Festool D27 antistatic hose seats on the Ryobi sander port with no reducer.
END A36.5 mmRyobi sander port (1-7/16 in ID)
END B35 mmFestool D27 antistatic hose (35 mm tip in OD, 7/8 in ID)
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Ryobi sander port (1-7/16 in ID) |
|---|---|
| End B | Festool D27 antistatic hose (35 mm tip in OD, 7/8 in ID) |
| Fit type | hose cuff into female socket |
| Reducer needed | none, direct friction fit |
Shop notes
The hose tip measures about 35 mm and the port socket about 36 mm, only 1 mm apart, so the hose tip seats inside the port socket as a friction fit. No reducer is needed for this pairing, so the Ryobi sander port and the Festool D27 antistatic hose connect directly.
It is a push fit, not a lock. Seat it fully and check it has not crept loose after a few minutes of vibration before you trust it on fine dust.
Related connections
- Ryobi sander port1.42 in / 36 mm ID
- Festool D27 antistatic hose27 mm nominal, tip 23 mm ID / 35 mm OD
- DeWalt DWS779 / DWS780 miter saw port to Festool D27 antistatic hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Festool D27 antistatic hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Festool D27 antistatic hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Festool D27 antistatic hoseneeds a reducer