CONNECTION
Connect a Ryobi miter saw port to a Festool D36 antistatic hose
How to join a Ryobi miter saw port to a Festool D36 antistatic hose, and what stops it leaking dust.
Direct fit
These connect directly. A Festool D36 antistatic hose seats on the Ryobi miter saw port with no reducer.
END B44 mmFestool D36 antistatic hose (44 mm tip in OD, 1-1/2 in ID)
END A36 mmRyobi miter saw port (1-7/16 in OD, 36 mm OD)
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Ryobi miter saw port (1-7/16 in OD, 36 mm OD) |
|---|---|
| End B | Festool D36 antistatic hose (44 mm tip in OD, 1-1/2 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | none, direct friction fit |
Shop notes
The port measures about 36 mm and the hose about 38 mm, only 2 mm apart, so the port seats inside the hose as a friction fit. No reducer is needed for this pairing, so the Ryobi miter saw port and the Festool D36 antistatic hose connect directly.
It is a push fit, not a lock. Seat it fully and check it has not crept loose after a few minutes of vibration before you trust it on fine dust.
Related connections
- Ryobi miter saw port1-7/16 in OD (approx 36 mm)
- Festool D36 antistatic hose36 mm nominal, tip 38 mm ID / 44 mm OD
- DeWalt DWS779 / DWS780 miter saw port to Festool D36 antistatic hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Festool D36 antistatic hosedirect fit
- DeWalt random-orbit sander stepped port to Festool D36 antistatic hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Festool D36 antistatic hoseneeds a reducer