Connect a Mirka DEROS sander port to a Makita 38 mm hose
How to join a Mirka DEROS sander port to a Makita 38 mm hose, and what stops it leaking dust.
Not a direct fit. Joining the Mirka DEROS sander port to a Makita 38 mm hose needs a 27 mm to 38 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Mirka DEROS sander port (1-1/16 in OD, 27 mm OD) |
|---|---|
| End B | Makita 38 mm hose (1-1/2 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | 27 mm to 38 mm step reducer |
Shop notes
Measured across the joint between the Mirka DEROS sander port and the Makita 38 mm hose, the hose (38 mm) is 11 mm larger than the port (27 mm), so the port rattles inside without gripping. A 27 mm to 38 mm step reducer closes that 11 mm step so the two hold together instead of leaking at the gap.
A 11 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
The reducer to buy
Shop 27 mm to 38 mm step reducer on AmazonaffiliateFind 27 mm to 38 mm step reducer on eBayaffiliateRelated connections
- Mirka DEROS sander port27 mm hose connection
- Makita 38 mm hose38 mm (1-1/2 in)
- DeWalt DWS779 / DWS780 miter saw port to Makita 38 mm hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Makita 38 mm hosedirect fit
- DeWalt random-orbit sander stepped port to Makita 38 mm hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Makita 38 mm hoseneeds a reducer