Connect a Makita 24 mm tool cuff to a 2-1/2 in Ridgid / Craftsman locking hose
How to join a Makita 24 mm tool cuff to a 2-1/2 in Ridgid / Craftsman locking hose, and what stops it leaking dust.
Not compatible without stepping down. A 2-1/2 in Ridgid / Craftsman locking hose is far larger than the Makita 24 mm tool cuff, so it needs a 24 mm to 2-1/2 in step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Makita 24 mm tool cuff (15/16 in OD, 24 mm OD) |
|---|---|
| End B | 2-1/2 in Ridgid / Craftsman locking hose (2-1/4 in OD, 2-1/4 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | 24 mm to 2-1/2 in step reducer |
Shop notes
The port is about 24 mm and the hose about 57 mm, a gap of 33 mm, so the hose simply swallows the port with no contact. A 24 mm to 2-1/2 in step reducer is needed, and even reduced the airflow is mismatched between the Makita 24 mm tool cuff and the 2-1/2 in Ridgid / Craftsman locking hose.
Wrapping tape to close a 33 mm gap never seals cleanly and chokes the airflow further. Step the sizes properly, or pair each end with a fitting closer to its own size.
The reducer to buy
Search Amazon for 24 mm to 2-1/2 in step reduceraffiliate searchRelated connections
- Makita 24 mm tool cuff24 mm / 22 mm cuff for 1 in hose
- 2-1/2 in Ridgid / Craftsman locking hose2-1/2 in, cuff approx 2-1/4 in OD
- DeWalt DWS779 / DWS780 miter saw port to 2-1/2 in Ridgid / Craftsman locking hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to 2-1/2 in Ridgid / Craftsman locking hoseneeds a reducer
- DeWalt random-orbit sander stepped port to 2-1/2 in Ridgid / Craftsman locking hoseneeds a reducer
- DeWalt DW735 planer port to 2-1/2 in Ridgid / Craftsman locking hoseneeds a reducer