Connect a Makita LS1019L miter saw port to a Festool D36 antistatic hose
How to join a Makita LS1019L miter saw port to a Festool D36 antistatic hose, and what stops it leaking dust.
Not a direct fit. Joining the Makita LS1019L miter saw port to a Festool D36 antistatic hose needs a 1-3/8 in to 36 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Makita LS1019L miter saw port (1-3/8 in ID) |
|---|---|
| End B | Festool D36 antistatic hose (44 mm tip in OD, 1-1/2 in ID) |
| Fit type | hose cuff into female socket |
| Reducer needed | 1-3/8 in to 36 mm step reducer |
Shop notes
Measured across the joint between the Makita LS1019L miter saw port and the Festool D36 antistatic hose, the hose tip (44 mm) is 9 mm larger than the port socket (35 mm), so it will not seat. A 1-3/8 in to 36 mm step reducer closes that 9 mm step so the two hold together instead of leaking at the gap.
A 9 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
The reducer to buy
Search Amazon for 1-3/8 in to 36 mm step reduceraffiliate searchRelated connections
- Makita LS1019L miter saw portapprox 1-3/8 in ID (35 mm)
- Festool D36 antistatic hose36 mm nominal, tip 38 mm ID / 44 mm OD
- DeWalt DWS779 / DWS780 miter saw port to Festool D36 antistatic hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Festool D36 antistatic hosedirect fit
- DeWalt random-orbit sander stepped port to Festool D36 antistatic hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Festool D36 antistatic hoseneeds a reducer