Connect a Fein 30 mm tool port to a Festool D50 antistatic hose
How to join a Fein 30 mm tool port to a Festool D50 antistatic hose, and what stops it leaking dust.
Not a direct fit. Joining the Fein 30 mm tool port to a Festool D50 antistatic hose needs a 30 mm to 50 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Fein 30 mm tool port (1-3/16 in OD, 30 mm OD) |
|---|---|
| End B | Festool D50 antistatic hose (1-15/16 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | 30 mm to 50 mm step reducer |
Shop notes
Measured across the joint between the Fein 30 mm tool port and the Festool D50 antistatic hose, the hose (50 mm) is 20 mm larger than the port (30 mm), so the port rattles inside without gripping. A 30 mm to 50 mm step reducer closes that 20 mm step so the two hold together instead of leaking at the gap.
A 20 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
The reducer to buy
Search Amazon for 30 mm to 50 mm step reduceraffiliate searchRelated connections
- Fein 30 mm tool port30 mm OD (Fein small-tool port)
- Festool D50 antistatic hose50 mm nominal (1-15/16 in)
- DeWalt DWS779 / DWS780 miter saw port to Festool D50 antistatic hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Festool D50 antistatic hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Festool D50 antistatic hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Festool D50 antistatic hoseneeds a reducer