CONNECTION
Connect a DeWalt DWE7491RS blade-guard port to a Makita 38 mm hose
How to join a DeWalt DWE7491RS blade-guard port to a Makita 38 mm hose, and what stops it leaking dust.
Direct fit
These connect directly. A Makita 38 mm hose seats on the DeWalt DWE7491RS blade-guard port with no reducer.
END A38 mmDeWalt DWE7491RS blade-guard port (1-1/2 in OD, 38 mm OD)
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | DeWalt DWE7491RS blade-guard port (1-1/2 in OD, 38 mm OD) |
|---|---|
| End B | Makita 38 mm hose (1-1/2 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | none, direct friction fit |
Shop notes
The port measures about 38 mm and the hose about 38 mm, the same, so the port seats inside the hose as a friction fit. No reducer is needed for this pairing, so the DeWalt DWE7491RS blade-guard port and the Makita 38 mm hose connect directly.
It is a push fit, not a lock. Seat it fully and check it has not crept loose after a few minutes of vibration before you trust it on fine dust.
Related connections
- DeWalt DWE7491RS blade-guard port1-1/2 in OD guard port
- Makita 38 mm hose38 mm (1-1/2 in)
- DeWalt DWS779 / DWS780 miter saw port to Makita 38 mm hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Makita 38 mm hosedirect fit
- DeWalt random-orbit sander stepped port to Makita 38 mm hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Makita 38 mm hoseneeds a reducer