Connect a DeWalt DWE7491RS blade-guard port to a Festool D50 antistatic hose
How to join a DeWalt DWE7491RS blade-guard port to a Festool D50 antistatic hose, and what stops it leaking dust.
Not a direct fit. Joining the DeWalt DWE7491RS blade-guard port to a Festool D50 antistatic hose needs a 1-1/2 in to 50 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | DeWalt DWE7491RS blade-guard port (1-1/2 in OD, 38 mm OD) |
|---|---|
| End B | Festool D50 antistatic hose (1-15/16 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | 1-1/2 in to 50 mm step reducer |
Shop notes
Measured across the joint between the DeWalt DWE7491RS blade-guard port and the Festool D50 antistatic hose, the hose (50 mm) is 12 mm larger than the port (38 mm), so the port rattles inside without gripping. A 1-1/2 in to 50 mm step reducer closes that 12 mm step so the two hold together instead of leaking at the gap.
A 12 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
The reducer to buy
Search Amazon for 1-1/2 in to 50 mm step reduceraffiliate searchRelated connections
- DeWalt DWE7491RS blade-guard port1-1/2 in OD guard port
- Festool D50 antistatic hose50 mm nominal (1-15/16 in)
- DeWalt DWS779 / DWS780 miter saw port to Festool D50 antistatic hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Festool D50 antistatic hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Festool D50 antistatic hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Festool D50 antistatic hoseneeds a reducer