Connect a Oneida Dust Deputy 2-1/2 in inlet to a Festool D27 antistatic hose
How to join a Oneida Dust Deputy 2-1/2 in inlet to a Festool D27 antistatic hose, and what stops it leaking dust.
Not a direct fit. Joining the Oneida Dust Deputy 2-1/2 in inlet to a Festool D27 antistatic hose needs a 2-1/2 in to 27 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Oneida Dust Deputy 2-1/2 in inlet (2-1/4 in ID) |
|---|---|
| End B | Festool D27 antistatic hose (35 mm tip in OD, 7/8 in ID) |
| Fit type | hose cuff into female socket |
| Reducer needed | 2-1/2 in to 27 mm step reducer |
Shop notes
Measured across the joint between the Oneida Dust Deputy 2-1/2 in inlet and the Festool D27 antistatic hose, the port socket (57 mm) is 22 mm larger than the hose tip (35 mm), so the hose tip rattles inside without gripping. A 2-1/2 in to 27 mm step reducer closes that 22 mm step so the two hold together instead of leaking at the gap.
A 22 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
The reducer to buy
Shop 2-1/2 in to 27 mm step reducer on AmazonaffiliateFind 2-1/2 in to 27 mm step reducer on eBayaffiliateRelated connections
- Oneida Dust Deputy 2-1/2 in inlet2-1/2 in inlet / outlet
- Festool D27 antistatic hose27 mm nominal, tip 23 mm ID / 35 mm OD
- DeWalt DWS779 / DWS780 miter saw port to Festool D27 antistatic hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Festool D27 antistatic hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Festool D27 antistatic hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Festool D27 antistatic hoseneeds a reducer