PortMatchMatch any tool dust port to any shop-vac or collector hose, with the exact reducer

Not compatible without stepping down. A 4 in dust-collector hose is far larger than the Cyclone collector 6 in inlet, so it needs a 6 in to 4 in step reducer. Measured OD and ID of each end, the real-world trap, and the exact reducer to buy.

Updated 05 September 2026.

CONNECTION

Connect a Cyclone collector 6 in inlet to a 4 in dust-collector hose

How to join a Cyclone collector 6 in inlet to a 4 in dust-collector hose, and what stops it leaking dust.

Not compatible

Not compatible without stepping down. A 4 in dust-collector hose is far larger than the Cyclone collector 6 in inlet, so it needs a 6 in to 4 in step reducer.

END A152.4 mmCyclone collector 6 in inlet (6 in ID)
END B101.6 mm4 in dust-collector hose (4-1/4 port in OD, 4 in ID)

Rings drawn to scale from the measured diameters in the table below.

The two ends

End ACyclone collector 6 in inlet (6 in ID)
End B4 in dust-collector hose (4-1/4 port in OD, 4 in ID)
Fit typehose cuff into female socket
Reducer needed6 in to 4 in step reducer

Shop notes

The hose tip is about 102 mm and the port socket about 152 mm, a gap of 50 mm, so the port socket simply swallows the hose tip with no contact. A 6 in to 4 in step reducer is needed, and even reduced the airflow is mismatched between the Cyclone collector 6 in inlet and the 4 in dust-collector hose.

Wrapping tape to close a 50 mm gap never seals cleanly and chokes the airflow further. Step the sizes properly, or pair each end with a fitting closer to its own size.

The reducer to buy

Shop 6 in to 4 in step reducer on AmazonaffiliateFind 6 in to 4 in step reducer on eBayaffiliate

Related connections

Questions and answers

Connect a Cyclone collector 6 in inlet to a 4 in dust-collector hose?

Not compatible without stepping down. A 4 in dust-collector hose is far larger than the Cyclone collector 6 in inlet, so it needs a 6 in to 4 in step reducer.