Connect a 4 in dust-collector hose to a 5 in dust-collector hose
How to join a 4 in dust-collector hose to a 5 in dust-collector hose, and what stops it leaking dust.
Not compatible without stepping down. A 5 in dust-collector hose is far larger than the 4 in dust-collector hose, so it needs a 4 in to 5 in step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | 4 in dust-collector hose (4-1/4 port in OD, 4 in ID) |
|---|---|
| End B | 5 in dust-collector hose (5 in ID) |
| Fit type | cuff to cuff via a step reducer |
| Reducer needed | 4 in to 5 in step reducer |
Shop notes
The smaller hose is about 102 mm and the hose about 127 mm, a gap of 25 mm, so the hose simply swallows the smaller hose with no contact. A 4 in to 5 in step reducer is needed, and even reduced the airflow is mismatched between the 4 in dust-collector hose and the 5 in dust-collector hose.
Wrapping tape to close a 25 mm gap never seals cleanly and chokes the airflow further. Step the sizes properly, or pair each end with a fitting closer to its own size.
The reducer to buy
Shop 4 in to 5 in step reducer on AmazonaffiliateFind 4 in to 5 in step reducer on eBayaffiliateRelated connections
- 4 in dust-collector hose4 in ID
- 5 in dust-collector hose5 in ID (approx 127 mm)
- SawStop table-saw rear guard port to 4 in dust-collector hosenot compatible
- 4 in dust-collector hose to 2-1/2 in shop-vac hoseneeds a reducer
- DeWalt DWS779 / DWS780 miter saw port to 4 in dust-collector hosenot compatible
- DeWalt miter saw dust elbow (1-1/2 in outer) to 4 in dust-collector hosenot compatible