CONNECTION
Connect a Bosch GTS1031 table saw port to a Festool D50 antistatic hose
How to join a Bosch GTS1031 table saw port to a Festool D50 antistatic hose, and what stops it leaking dust.
Direct fit
These connect directly. A Festool D50 antistatic hose seats on the Bosch GTS1031 table saw port with no reducer.
END A51 mmBosch GTS1031 table saw port (2 in OD, 51 mm OD)
END B49.2 mmFestool D50 antistatic hose (1-15/16 in ID)
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Bosch GTS1031 table saw port (2 in OD, 51 mm OD) |
|---|---|
| End B | Festool D50 antistatic hose (1-15/16 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | none, direct friction fit |
Shop notes
The port measures about 51 mm and the hose about 50 mm, only 1 mm apart, so the port seats inside the hose as a friction fit. No reducer is needed for this pairing, so the Bosch GTS1031 table saw port and the Festool D50 antistatic hose connect directly.
It is a push fit, not a lock. Seat it fully and check it has not crept loose after a few minutes of vibration before you trust it on fine dust.
Related connections
- Bosch GTS1031 table saw port2 in dust port
- Festool D50 antistatic hose50 mm nominal (1-15/16 in)
- DeWalt DWS779 / DWS780 miter saw port to Festool D50 antistatic hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Festool D50 antistatic hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Festool D50 antistatic hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Festool D50 antistatic hoseneeds a reducer