Connect a Bosch GTS1031 table saw port to a Fein Turbo 35 mm hose
How to join a Bosch GTS1031 table saw port to a Fein Turbo 35 mm hose, and what stops it leaking dust.
Not a direct fit. Joining the Bosch GTS1031 table saw port to a Fein Turbo 35 mm hose needs a 2 in to 35 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Bosch GTS1031 table saw port (2 in OD, 51 mm OD) |
|---|---|
| End B | Fein Turbo 35 mm hose (1-3/8 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | 2 in to 35 mm step reducer |
Shop notes
Measured across the joint between the Bosch GTS1031 table saw port and the Fein Turbo 35 mm hose, the port (51 mm) is 16 mm larger than the hose (35 mm), so it will not seat. A 2 in to 35 mm step reducer closes that 16 mm step so the two hold together instead of leaking at the gap.
A 16 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
The reducer to buy
Search Amazon for 2 in to 35 mm step reduceraffiliate searchRelated connections
- Bosch GTS1031 table saw port2 in dust port
- Fein Turbo 35 mm hose35 mm diameter
- DeWalt DWS779 / DWS780 miter saw port to Fein Turbo 35 mm hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Fein Turbo 35 mm hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Fein Turbo 35 mm hosedirect fit
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Fein Turbo 35 mm hosedirect fit