Connect a Bosch GTS 10 table saw port to a 4 in dust-collector hose
How to join a Bosch GTS 10 table saw port to a 4 in dust-collector hose, and what stops it leaking dust.
Not compatible without stepping down. A 4 in dust-collector hose is far larger than the Bosch GTS 10 table saw port, so it needs a 63 mm to 4 in step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Bosch GTS 10 table saw port (2-1/2 in OD, 63 mm OD) |
|---|---|
| End B | 4 in dust-collector hose (4-1/4 port in OD, 4 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | 63 mm to 4 in step reducer |
Shop notes
The port is about 63 mm and the hose about 102 mm, a gap of 39 mm, so the hose simply swallows the port with no contact. A 63 mm to 4 in step reducer is needed, and even reduced the airflow is mismatched between the Bosch GTS 10 table saw port and the 4 in dust-collector hose.
Wrapping tape to close a 39 mm gap never seals cleanly and chokes the airflow further. Step the sizes properly, or pair each end with a fitting closer to its own size.
The reducer to buy
Search Amazon for 63 mm to 4 in step reduceraffiliate searchRelated connections
- Bosch GTS 10 table saw port63 mm rear port, adapter 57 mm OD saw / 39 mm OD vac
- 4 in dust-collector hose4 in ID
- SawStop table-saw rear guard port to 4 in dust-collector hosenot compatible
- 4 in dust-collector hose to 2-1/2 in shop-vac hoseneeds a reducer
- DeWalt DWS779 / DWS780 miter saw port to 4 in dust-collector hosenot compatible
- DeWalt miter saw dust elbow (1-1/2 in outer) to 4 in dust-collector hosenot compatible