Connect a Bosch GCM12SD miter saw port to a Festool D32/22 antistatic hose
How to join a Bosch GCM12SD miter saw port to a Festool D32/22 antistatic hose, and what stops it leaking dust.
Not a direct fit. Joining the Bosch GCM12SD miter saw port to a Festool D32/22 antistatic hose needs a 1-1/4 in to 22 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Bosch GCM12SD miter saw port (1-1/4 in ID) |
|---|---|
| End B | Festool D32/22 antistatic hose (7/8 in ID) |
| Fit type | hose cuff into female socket |
| Reducer needed | 1-1/4 in to 22 mm step reducer |
Shop notes
Measured across the joint between the Bosch GCM12SD miter saw port and the Festool D32/22 antistatic hose, the port socket (32 mm) is 10 mm larger than the hose tip (22 mm), so the hose tip rattles inside without gripping. A 1-1/4 in to 22 mm step reducer closes that 10 mm step so the two hold together instead of leaking at the gap.
A 10 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
The reducer to buy
Search Amazon for 1-1/4 in to 22 mm step reduceraffiliate searchRelated connections
- Bosch GCM12SD miter saw portrear approx 1-1/4 in ID (32 mm)
- Festool D32/22 antistatic hose22 mm tool end, tapered to 32 mm
- DeWalt DWS779 / DWS780 miter saw port to Festool D32/22 antistatic hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Festool D32/22 antistatic hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Festool D32/22 antistatic hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Festool D32/22 antistatic hoseneeds a reducer