CONNECTION
Connect a Bosch CM10GD miter saw port to a Numatic Henry 32 mm hose
How to join a Bosch CM10GD miter saw port to a Numatic Henry 32 mm hose, and what stops it leaking dust.
Direct fit
These connect directly. A Numatic Henry 32 mm hose seats on the Bosch CM10GD miter saw port with no reducer.
END B32 mmNumatic Henry 32 mm hose (1-1/4 in ID)
END A31.8 mmBosch CM10GD miter saw port (1-1/4 in ID)
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Bosch CM10GD miter saw port (1-1/4 in ID) |
|---|---|
| End B | Numatic Henry 32 mm hose (1-1/4 in ID) |
| Fit type | hose cuff into female socket |
| Reducer needed | none, direct friction fit |
Shop notes
The hose tip measures about 32 mm and the port socket about 32 mm, the same, so the hose tip seats inside the port socket as a friction fit. No reducer is needed for this pairing, so the Bosch CM10GD miter saw port and the Numatic Henry 32 mm hose connect directly.
It is a push fit, not a lock. Seat it fully and check it has not crept loose after a few minutes of vibration before you trust it on fine dust.
Related connections
- Bosch CM10GD miter saw portrear approx 1-1/4 in ID (32 mm)
- Numatic Henry 32 mm hose32 mm (1-1/4 in)
- DeWalt DWS779 / DWS780 miter saw port to Numatic Henry 32 mm hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Numatic Henry 32 mm hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Numatic Henry 32 mm hoseneeds a reducer
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Numatic Henry 32 mm hoseneeds a reducer