Connect a Bosch 27 mm tool port to a Fein Turbo 35 mm hose
How to join a Bosch 27 mm tool port to a Fein Turbo 35 mm hose, and what stops it leaking dust.
Not a direct fit. Joining the Bosch 27 mm tool port to a Fein Turbo 35 mm hose needs a 27 mm to 35 mm step reducer.
Rings drawn to scale from the measured diameters in the table below.
The two ends
| End A | Bosch 27 mm tool port (1-1/16 in OD, 27 mm OD) |
|---|---|
| End B | Fein Turbo 35 mm hose (1-3/8 in ID) |
| Fit type | male port into hose cuff |
| Reducer needed | 27 mm to 35 mm step reducer |
Shop notes
Measured across the joint between the Bosch 27 mm tool port and the Fein Turbo 35 mm hose, the hose (35 mm) is 8 mm larger than the port (27 mm), so the port rattles inside without gripping. A 27 mm to 35 mm step reducer closes that 8 mm step so the two hold together instead of leaking at the gap.
A 8 mm mismatch feels close enough to force, and it will hold for a minute before it works loose under airflow. Fit the step ring rather than trusting friction on a gap this size.
The reducer to buy
Search Amazon for 27 mm to 35 mm step reduceraffiliate searchRelated connections
- Bosch 27 mm tool port27 mm OD
- Fein Turbo 35 mm hose35 mm diameter
- DeWalt DWS779 / DWS780 miter saw port to Fein Turbo 35 mm hoseneeds a reducer
- DeWalt miter saw dust elbow (1-1/2 in outer) to Fein Turbo 35 mm hoseneeds a reducer
- DeWalt random-orbit sander stepped port to Fein Turbo 35 mm hosedirect fit
- 35 mm EU power-tool port (DeWalt / Bosch / Makita) to Fein Turbo 35 mm hosedirect fit